3M™ Cold Shrink Splice Kit 5552, 5/8 kV, 4/0 AWG-500 kcmil (Cu) or 4/0 AWG-400 kcmil (Al), 21 in, 1/case
- Part Number 5552
- 3M ID 7000006047
- UPC 00054007090908
Details
Highlights
- Provides splicing on tape shield, wire shield and UniShield® cables
- This kit is suitable for use on solid dielectric cables, indoor or outdoor locations and direct-burial applications
- Insulator and jacket is made of EPDM for easy installation
- Rated for 5/8 kV applications
- IEEE Approved
3M™ Cold Shrink Shielded Splice Kit 5550 Series are for splicing 5 kV and 8 kV shielded, solid dielectric, power cables.
Meeting the requirements of IEEE 404, each 3M™ Cold Shrink Shielded Splice Kit 5550 Series kit contains all the materials (except connectors and optional ground strap) required to construct three (3) single conductor splices on Tape Shield, Wire Shield or UniShield® cables. Note: The kit can also be used to splice a shielded to a non-shielded 5/8 kV cable. Note: Cable sizes shown below are for standard insulation thickness. Final determining factor is cable insulation outside diameter
Typical properties
Resources
Legal disclaimer
The designation that a product is Manufactured in the USA means the product undergoes substantial transformation in one of our U.S. Manufacturing plants. Some products contain imported components.
Note: 3M products offered on a government contract that require country of origin representation must be certified by 3M Trade Compliance. Contact customer service at 800-245-3573 to request a certificate.
For industrial/occupational use only. Not for consumer sale or use.
3M industrial and occupational products are intended, labeled, and packaged for sale to trained industrial and occupational customers for workplace use. Unless specifically stated otherwise on the applicable product packaging or literature, these products are not intended, labeled, or packaged for sale to or use by consumers (e.g., for home, personal, primary or secondary school, recreational/sporting, or other uses not described in the applicable product packaging or literature), and must be selected and used in compliance with applicable health and safety regulations and standards (e.g., U.S. OSHA, ANSI), as well as all product literature, user instructions, warnings, and other limitations, and the user must take any action required under any recall, field action, or other product use notice. Misuse of 3M industrial and occupational products may result in injury, sickness, death, or property damage. For help with product selection and use, consult your on-site safety professional, industrial hygienist, or other subject matter expert.
