3M™ Cold Shrink Transition Splice Kit QS2012-3T-WS, Tape, Wire, UniShield®, EP-Lead or XLP-Lead, 1/case

  • Part Number QS2012-3T-WS
  • 3M ID 7100164637
  • UPC 00054007042112

Specially designed splice to connect a 3/C paper insulated lead covered (PILC) cable to three 1/C Poly/EPR insulated cables

Poly/EPR cables include CN, JCN, LC, tape shield, wire shield, poly/EP lead or UniShield® cables

Mastic components seal at Poly/EPR cable jacket ends

View more details
Frequently viewed resources
Tech Data Sheet (PDF, 927KB)Safety Data Sheet (PDF, 0B)

Details

Highlights
  • Specially designed splice to connect a 3/C paper insulated lead covered (PILC) cable to three 1/C Poly/EPR insulated cables
  • Poly/EPR cables include CN, JCN, LC, tape shield, wire shield, poly/EP lead or UniShield® cables
  • Mastic components seal at Poly/EPR cable jacket ends
  • Poly/EPR cable has 0.88 to 1.36-in insulation O.D
  • Accommodates 4/0 AWG to 500 kcmil size Poly/EPR cable conductor
  • Silicone rubber-splice body controls the electrical field of the high voltage over the connector
  • Rated for 15 kV cables
  • Meets the requirements of IEEE 404 standards

3M™ QS2011-3T-WS Series Cold Shrink Trifurcating Transition Splice Kit is a specially designed 15kV splice to connect a 3/C paper insulated lead covered (PILC) cable to three 1/C Poly/EPR insulated cables. Poly/EPR cables include CN, JCN, LC, tape shield, wire shield, poly/EP lead or UniShield® cables. It uses wraparound heat shrink rejacketing.

3M™ QS2011-3T-WS Cold Shrink Trifurcating Transition Splice Kit includes 2 bags with components to seal oil inside and to seal the phase conductors of the PILC cable. The kit contains cold shrink splice bodies, an overall shield sleeve, heat shrink breakout boot, moisture sealing mastic materials, ground braid connectors, copper ground braids, resin and a heat shrink wraparound jacket sleeve. It is suitable to use on cables that can withstand a maximum temperature of 90 degrees C. The kit meets the requirements of IEEE 404 standards.

Typical properties

Resources

For industrial/occupational use only. Not for consumer sale or use.

3M industrial and occupational products are intended, labeled, and packaged for sale to trained industrial and occupational customers for workplace use.  Unless specifically stated otherwise on the applicable product packaging or literature, these products are not intended, labeled, or packaged for sale to or use by consumers (e.g., for home, personal, primary or secondary school, recreational/sporting, or other uses not described in the applicable product packaging or literature), and must be selected and used in compliance with applicable health and safety regulations and standards (e.g., U.S. OSHA, ANSI), as well as all product literature, user instructions, warnings, and other limitations, and the user must take any action required under any recall, field action, or other product use notice.  Misuse of 3M industrial and occupational products may result in injury, sickness, death, or property damage.  For help with product selection and use, consult your on-site safety professional, industrial hygienist, or other subject matter expert.