3M™ Industrial Insulated Protective Cap Kit is an accessory device designed to electrically insulate and mechanically seal loadbreak bushing interfaces. The protective cap is used for permanent or temporary installation on bushings, junctions or feed thru devices. This kit is 15 kV voltage rated and 200 amp current rated.
3M™ Industrial Insulated Protective Cap Kit includes an insulated protective cap with stranded copper ground wire, silicone lubricant and an installation instruction sheet. The protective cap offers a fully shielded insulating cover for energized bushings that meet the requirements of ANS/IEEE Standard 386.
3M industrial and occupational products are intended, labeled, and packaged for sale to trained industrial and occupational customers for workplace use. Unless specifically stated otherwise on the applicable product packaging or literature, these products are not intended, labeled, or packaged for sale to or use by consumers (e.g., for home, personal, primary or secondary school, recreational/sporting, or other uses not described in the applicable product packaging or literature), and must be selected and used in compliance with applicable health and safety regulations and standards (e.g., U.S. OSHA, ANSI), as well as all product literature, user instructions, warnings, and other limitations, and the user must take any action required under any recall, field action, or other product use notice. Misuse of 3M industrial and occupational products may result in injury, sickness, death, or property damage. For help with product selection and use, consult your on-site safety professional, industrial hygienist, or other subject matter expert.