3M™ Cubitron™ II Hookit™ Film Disc 775L, 120+ 3MIL, 5 in x NH, Die 500X, 50/Carton, 250 ea/Case

For industrial/occupational use only. Not for consumer sale or use.

3M industrial and occupational products are intended, labeled, and packaged for sale to trained industrial and occupational customers for workplace use. Unless specifically stated otherwise on the applicable product packaging or literature, these products are not intended, labeled, or packaged for sale to or use by consumers (e.g., for home, personal, primary or secondary school, recreational/sporting, or other uses not described in the applicable product packaging or literature), and must be selected and used in compliance with applicable health and safety regulations and standards (e.g., U.S. OSHA, ANSI), as well as all product literature, user instructions, warnings, and other limitations, and the user must take any action required under any recall, field action, or other product use notice. Misuse of 3M industrial and occupational products may result in injury, sickness, death, or property damage. For help with product selection and use, consult your on-site safety professional, industrial hygienist, or other subject matter expert. ¹ Cuts up to twice as fast: Compared to 3M Aluminum Oxide Abrasive Products. Results are based on total cut over four × ninety-second cycles on an automated test with maple material using 5 inch (127 mm) 80 grit discs and 3M Xtract^™ Low Profile Finishing Back-up Pad 20290. Factors affecting disc performance include (but are not limited to) tool type and performance, tool orbit, disc back-up pad, grade, substrate, operator pressure, and dust extraction system. Achieving more than 2× is possible with an optimized system. ² Lasts up to six times as long: Compared to 3M Aluminum Oxide Abrasive Products. Results are based on total cut over twenty-four × ninety-second cycles on an automated test with maple material using 5 inch (127 mm) 180 grit discs and 3M Xtract^™ Low Profile Finishing Back-up Pad 20290. End of life is defined as when the 3M disc cut rate drops to 75% of the initial cut rate of the conventional abrasive disc. Factors affecting disc performance include (but are not limited to) tool type and performance, tool orbit, disc back-up pad, grade, substrate, operator pressure, and dust extraction system.