1. United States
  2. All 3M Products
  3. Electrical
  4. Wire & Cable
  5. Tubing & Molded Parts
  6. Cable Sleeves
  7. 3M™ Rejacketing Sleeve RJS-1, 4 ft coil, 10 /Case

3M™ Rejacketing Sleeve RJS-1, 4 ft coil, 10 /Case

  • Part Number RJS-1-4FT
  • 3M ID 7000006143
  • UPC 00054007430988

Offers good resistance to moisture, corrosion, ozone and UV rays

Secures the phase legs of medium-voltage and 3/C shielded power cables

Designed for use on tape shield, wire shield, armored and non-armored power cables

View more details
Frequently viewed resources
Tech Data Sheet (PDF, 578KB)
Inner Diameter After Shrink (Metric) 10.9 mm
Inner Diameter Before Shrink (Metric) 15.2 mm
Inner Diameter After Shrink (Imperial) 0.4 in
Inner Diameter Before Shrink (Imperial) 0.6 in
Overall Length (Metric) 1,219 mm
Overall Length (Imperial) 4 ft

Details

Highlights
  • Offers good resistance to moisture, corrosion, ozone and UV rays
  • Secures the phase legs of medium-voltage and 3/C shielded power cables
  • Designed for use on tape shield, wire shield, armored and non-armored power cables
  • Comes in dark gray color
  • Silicone rubber insulator on inner-expandable polyester braid minimizes sliding friction and ensures a leak-proof seal
  • Voltages of up to 35 kV or less

3M™ Rejacketing Sleeve provides reliable safety and protection to the phase legs of 3/C shielded, medium voltage power cables from termination operating environments. Incorporated with a silicone rubber insulator and polyester braid, this sleeve is resistant to UV rays, ozone, corrosion and moisture. It is designed for use with 3M Cold Shrink QT II and QT III, Silicone Rubber Terminations.

3M™ Rejacketing Sleeve works in combination with cold shrink breakout boots and silicone rubber terminations. It is ideal for tape shield, wire shield, armored and non armored power cables. The rejacketing sleeves are designed to protect the phase legs from exosure to: moisture, corrosion, ozone, ultra violet radiation and other hazards associated with termination operating environments. Easy to adjust length, the sleeve conforms to varied equipment connections and mounting requirements.

Typical properties

Resources

Manufacturing Origin: USA

The designation that a product is Manufactured in the USA means the product undergoes substantial transformation in one of our U.S. Manufacturing plants. Some products contain imported components.

Note: 3M products offered on a government contract that require country of origin representation must be certified by 3M Trade Compliance. Contact customer service at 800-245-3573 to request a certificate.
For industrial/occupational use only. Not for consumer sale or use.

3M industrial and occupational products are intended, labeled, and packaged for sale to trained industrial and occupational customers for workplace use.  Unless specifically stated otherwise on the applicable product packaging or literature, these products are not intended, labeled, or packaged for sale to or use by consumers (e.g., for home, personal, primary or secondary school, recreational/sporting, or other uses not described in the applicable product packaging or literature), and must be selected and used in compliance with applicable health and safety regulations and standards (e.g., U.S. OSHA, ANSI), as well as all product literature, user instructions, warnings, and other limitations, and the user must take any action required under any recall, field action, or other product use notice.  Misuse of 3M industrial and occupational products may result in injury, sickness, death, or property damage.  For help with product selection and use, consult your on-site safety professional, industrial hygienist, or other subject matter expert.