Scotch-Brite™ Clean and Finish Finishing Flap Brush, CF-FB, TS Red Core, 7A Very Fine, 6 in x 36 in x 3.15 in, 1 ea/Case
- 3M ID 7010329489
- UPC 00076308643225
Details
Highlights
- High-value brush with good performance for a variety of finishing applications in metalworking and woodworking
- Offered in a broad range of grades and densities
- Flap construction helps brush continually lap the surface, resulting in finer finishes
- Some brushes feature a Roloc™ or Roloc™+ attachment system for swift and easy connection to a die grinder
- May be used on a variety of substrates, including wood, metal and paint
The Scotch-Brite™ Clean and Finish Flap Brush was engineered to perform a variety of aesthetic finishing applications on wood and metals. Whether primer scuffing and wood defuzzing or removing metal burrs and imperfections, the flaps effectively clean up the workpiece while still delivering a consistent finish.
Sections of non-woven material slit lengthwise and bonded to a cylindrical core
Scotch-Brite™ Clean and Finish Flap Brush is a great brush for aesthetic finishing applications. Here's why. Brushes are infused with abrasive mineral to give uniform cut and finish throughout product life. The open, flexible flap construction is soft and pliable to produce uniform surface finishes without chatter marks. Flaps are secured to a fibre core and repeatedly lap the substrate's surface. As flaps lap the surface, they brush and finish areas that may have been passed over by more rigid abrasives — striking a balance between strength and finesse. Here's a list of applications this brush is commonly used for:
- Cleaning and light deburring
- Satin finishing on metal
- Defuzzing wood prior to varnishing
- Primer scuffing before final coat
This brush is offered in varying grades of silicon carbide and aluminum oxide mineral. Silicon carbide is a synthetic mineral that's very hard and sharp. It breaks down faster than aluminum oxide but delivers a finer finish. Conversely, aluminum oxide is very durable and lasts longer but finishes coarser than silicon carbide grade for grade. Project needs and requirements — be it aggressive removal or fine finish — will likely influence mineral choice. Independent of the mineral chosen, operators can rely on consistent results.
| Mineral Type | Brush Color | Grade | |
| Aluminum Oxide | Maroon | VFN, MED | |
| Silicon Carbide | Gray | MED | |
| Diameter (inches) |
Center Hole (inches) |
Width (inches) |
Density (inches) |
| 4 - 16 | 2, 3, 5, 8, 10 | 1/2 - 24 | 3, 5, 7 |
Mineral Performance Comparison
Typical properties
Resources
For industrial/occupational use only. Not for consumer sale or use.
3M industrial and occupational products are intended, labeled, and packaged for sale to trained industrial and occupational customers for workplace use. Unless specifically stated otherwise on the applicable product packaging or literature, these products are not intended, labeled, or packaged for sale to or use by consumers (e.g., for home, personal, primary or secondary school, recreational/sporting, or other uses not described in the applicable product packaging or literature), and must be selected and used in compliance with applicable health and safety regulations and standards (e.g., U.S. OSHA, ANSI), as well as all product literature, user instructions, warnings, and other limitations, and the user must take any action required under any recall, field action, or other product use notice. Misuse of 3M industrial and occupational products may result in injury, sickness, death, or property damage. For help with product selection and use, consult your on-site safety professional, industrial hygienist, or other subject matter expert.
