3M™ Trizact™ Film Belt 568XA
- | Select product options for IDs.
Details
Highlights
- Microreplicated cerium oxide delivers high gloss, crisp reflection, richer appearance
- Trizact mineral starts sharp and stay sharp, resulting in more predictable finishes and improved, consistent results
- Use wet for glass defect repair and solid surface finishing
- Precise, repeatable finishes from part to part
- Requires little water, easy touch up
The 3M™ Trizact™ Film Belt 568XA utilizes microreplicated cerium oxide and a 3-mil film backing to create a high gloss on glass, Corian and solid surfaces. Use 568XA film belts wet or dry.
Precise, repeatable finishes from part to part
Trizact™ features 3-dimensional structures uniformly distributed to ensures consistent performance
Used wet to repair glass defects and polish solid surfaces, acrylics and remove overspray or dirt on topcoats, our 3M™ Trizact™ Film Belt 568XA delivers higher throughput, more uniform results and greater productivity.
Finish and Repair Sensitive Surfaces
Designed with Trizact microreplicated cerium oxide, 568XA ensures a fast, consistent cut rate that easily removes defects such as scuffs, scratches and acid marks on table glass, airplane windscreens and windows, architectural glass and other solid surfaces. The film backing is water resistant and requires little water for touch-up, minimizing mess and processing steps.
About Cerium Oxide
Cerium oxide is an oxide of the rare earth metal, cerium. The average grain size of the particle is measured in nanometers in raw form, thus making it one of the most effective abrasives for final polishing steps on solid surface products. It is heat resistant and effective as a polishing agent for glass mirrors, plate glass, crystal, ophthalmic lenses, precision optics and precious and semiprecious stone
3M's 568XA cerium oxide Trizact™ belts are used with just water to polish surfaces that have been properly prepped for pre-polish.
Trizact Abrasives
3M™ Trizact™ abrasives are engineered using 3M microreplication — the creation of microscopic 3-dimensional structures applied to a backing in a uniform and precise pattern. These pyramid-like structures contain multiple layers of mineral. When they break down during use, fresh cutting mineral continues to be exposed so results are consistent throughout the life of the abrasive.
Typical properties
Resources
For industrial/occupational use only. Not for consumer sale or use.
3M industrial and occupational products are intended, labeled, and packaged for sale to trained industrial and occupational customers for workplace use. Unless specifically stated otherwise on the applicable product packaging or literature, these products are not intended, labeled, or packaged for sale to or use by consumers (e.g., for home, personal, primary or secondary school, recreational/sporting, or other uses not described in the applicable product packaging or literature), and must be selected and used in compliance with applicable health and safety regulations and standards (e.g., U.S. OSHA, ANSI), as well as all product literature, user instructions, warnings, and other limitations, and the user must take any action required under any recall, field action, or other product use notice. Misuse of 3M industrial and occupational products may result in injury, sickness, death, or property damage. For help with product selection and use, consult your on-site safety professional, industrial hygienist, or other subject matter expert.
