- Dynamar PPA FX 5917 can offer performance and cost advantage by direct comparison to other processing additives. It provides exceptional productivity benefit when used in high density polyethylene (HDPE) and in linear low density polyethylene (LLDPE) processing. It can also be used at very low levels to reduce extruder die build-up when processing LDPE, EVA and other polyolefin resins
- As a processing additive Dynamar PPA FX 5917 reduces or eliminates melt fracture and can reduce extruder torque. Through optimization of the extruder process, the use of FX 5917 may also allow to postpone the appearance of die lip build up in cast film processing resulting in a higher yield and reducing interfacial instability in the extrusion of multi-layer films
- Lowers apparent melt viscosity
- Broadens extrusion processing capabilities of polyolefin resins
3M™ Dynamar™ Polymer Processing Additive FX 5916
At the typical low use levels (200-1000 ppm) necessary to improve polyolefin processing, FX 5917 has no influence on the surface and mechanical properties. Special Features Copolymer of VF2 (vinylidene fluoride) and HFP (hexafluoropropylene), Eliminates melt fracture.
- Dynamar PPA FX 5917 can offer performance and cost advantage by direct comparison to other processing additives. It provides exceptional productivity benefit when used in high density polyethylene (HDPE) and in linear low density polyethylene (LLDPE) processing. It can also be used at very low levels to reduce extruder die build-up when processing LDPE, EVA and other polyolefin resins
- As a processing additive Dynamar PPA FX 5917 reduces or eliminates melt fracture and can reduce extruder torque. Through optimization of the extruder process, the use of FX 5917 may also allow to postpone the appearance of die lip build up in cast film processing resulting in a higher yield and reducing interfacial instability in the extrusion of multi-layer films
- Lowers apparent melt viscosity
- Broadens extrusion processing capabilities of polyolefin resins
- Reduces or eliminates die build-up
- Can offer performance and cost advantages
|
Attribute Name
|
Value
|
|---|---|
|
Capabilities
|
Color Changeover Improvement
|
|
Melt Flow Index (MFI)
|
2-6 g/10 min.
|
|
Melting point
|
160°C (320°F)
|
|
Processing Concern
|
Color Hangup, Limited Throughput, Melt Fracture to Clear
|
|
Product Form
|
Pellet
|
|
Shelf Life
|
2 Year
|
|
Weight (Metric)
|
25 Kilogram
|
Pošljite nam sporočilo
Zahvaljujemo se vam za zanimanje za 3M. Da bomo na vaše vprašanje odgovorili v najkrajšem možnem času, vas vljudno prosimo, da navedete nekaj ključnih informacij, vključno z vašimi kontaktnimi podatki. Na osnovi posredovanih podatkov, bo na vaše vprašanje odgovoril po e-pošti ali telefonu predstavnik podjetja ali eden od naših pooblaščenih poslovnih partnerjev, s katerimi bomo morda delili vaše osebne podatke v skladu s politiko zasebnosti 3M.
Zahvaljujemo se vam, da ste se obrnili na podjetje 3M
Prejeli smo vaše sporočilo in zdaj obravnavamo vašo poizvedbo
Naš predstavnik vas bo kontaktiral po telefonu ali e-pošti.
An error occurred.
