3M (East) AG Podružnica Slovenija

3M™ Scotch-Weld™ Structural Plastic Adhesive DP8005 Black, 35 mL, 12 per case

3M ID 62277904371
  • 3 minute work life
  • Structurally bonds polyolefins without surface treatment
  • Medium viscosity
  • Medium viscosity allows controlled dispensing
 Več...
Specifikacije
Adhesive Type
Akril
Consumer Label
Ne
Design Challenges
Noise Vibration & Harshness Control NVH
Full Cure Time
8-24 Hours @ 72 F (22 C)
Hardness
55-60 Shore D
Indoor/Outdoor
Both
Industries
Avtomobilska industrija, Gradnja, Consumer Goods, Electronics, General Industrial, Metalworking, Military and Government, Signage, Specialty Vehicle, Prevoz, Mizarstvo
Maximum Operating Temperature (Celsius)
66 Degree Celsius
Mix Ratio Volume Base:Accelerator
10 : 1
Open Time
3 minutes @ 72 F (22 C)
Physical Form
Flowable Liquid
Position
Best
Product Form
Kartuša
Product Type
Structural Plastic Adhesive
Shear Strength
2400 Pound_Per_Square_Inch
Shelf Life in Months (From Date of Manufacture)
6
Specific Gravity
0.99
Storage Temperature
40 Degree Fahrenheit
Substrate 1
Glass & Ceramics, Metal, Plastics (ABS, PVC, Acrylic), Plastics (High Performance Nylon), Plastics (Polyolefins and Thermoplastic Elastomers), Wood & Hardboard
Substrate 2
Glass & Ceramics, Metal, Plastics (ABS, PVC, Acrylic), Plastics (High Performance Nylon), Plastics (Polyolefins and Thermoplastic Elastomers), Wood & Hardboard
Units per Case
12
Viscosity Range (cps) at Room Temperature
25,000
Znamke
Scotch-Weld™
Podrobnosti
  • 3 minute work life
  • Structurally bonds polyolefins without surface treatment
  • Medium viscosity
  • Medium viscosity allows controlled dispensing
  • Solvent-free adhesive system
  • Strong adhesive can replace screws, rivets and welding

3M™ Scotch-Weld™ Structural Plastic Adhesive 8005 is a two-part acrylic based adhesive. 10:1 mix ratio, 3 minute work life and handing strength in approximately 3 hours.

3M™ Scotch-Weld™ Structural Plastic Adhesive 8005 can bond many low surface energy plastics, including many grades of Polypropylene, Polyethylene, and Thermoplastic Elastomers (TPE`s) without special surface preparation.