Using 3M LeadCheck Swabs on Plaster and Drywall Surfaces
Step by Step Instructions based on EPA recognition
3M™ LeadCheck™ Swab Demo on Painted Plaster and Drywall Surfaces
Sulfates present in drywall (gypsum) and plaster dust can interfere with 3M™ LeadCheck™ Swabs color development. It is possible with a minimum amount of care to accurately test for lead paint on plaster surfaces with 3M™ LeadCheck™ Swabs.
With a clean utility knife, make a nickel sized half circle cut at a low angle (about 5 degrees) cutting down to the bare drywall (gypsum) and plaster core to expose all layers of paint. Make the cut as seen in figure A.
Fold down the semicircular flap with the knife blade so that it forms a pocket.
Using an activated 3M™ LeadCheck™ Swab, hold the swab above the cut allowing the 3M™ LeadCheck™ reagent to flow into the pocket making sure that the liquid contacts all layers of paint both in the cut itself and the peeled back flap. Carefully rub the swab around the periphery of the peeled back flap, taking care not to contact the drywall (gypsum) or plaster. Only rub the swab on all layers of paint found on the flap. Do not rub the swab in the pocket.
If lead is present, a pink or red color will develop along the edges of the cut, flap, or swab tip usually within 30 seconds.
If no pink or red color develops, immediately confirm the negative result by squeezing a drop of the 3M™ LeadCheck™ reagent onto one of the confirmation card dots. It should turn red immediately.
Sign Up and get Special offers, valuable coupons and more
Thank You for Subscribing
Thank you for signing up! You should receive a welcome email with additional details shortly.
An error has occurred while submitting. Please try again later...
Please be aware that this information may be transferred to a server located in the United States for metrics and storage. If you do not consent to this use of your personal information, please do not use the email system.