3M™ Dirt Trap Protection Material Dispenser

Store and dispense 3M™ Dirt Trap Protection Material with 3M™ Dirt Trap Protection Material Dispenser. Our material dispenser has high strength magnets that secure it on vertical metal surfaces to dispense and apply the dirt trap material covering.

Unroll the right length of 3M™ Dirt Trap Protection Material with 3M™ Dirt Trap Protection Material Dispenser. Our durable metal material dispenser has high strength magnets that secure it on vertical metal surfaces to dispense and apply the dirt trap material covering. Just place the dispenser where you want and unroll the material. The magnets allow you to move the dispenser to another site if needed. Directions for installing 3M™ Dirt Trap Protection Material on walls ⦁ Install the first section closest to the floor and work your way up the wall ⦁ Attach the dispenser to the adjacent wall ⦁ Pull the fabric out to the length of the booth ⦁ Use the squeegee to attach the far end of the material at the corner ⦁ Work your way back to the dispenser aligning the material and attach to the wall ⦁ Cut the material at the dispenser ⦁ Squeegee the entire wall section to make sure it is attached completely ⦁ Re‐mount the dispenser at the level of the second section ⦁ Overlap the first section (1” or less) ⦁ Use the same method to finish installing 3 wall sections ⦁ After the third section is installed, cut out around the windows and light ⦁ Important – Material should be replaced prior to 150 bake cycles for clean and easy removal