3M in the United States
  1. 1230 Fire Protection Fluid
3M™ Novec™ 1230 Fire Protection Fluid is an HFC alternative that works fast, clean and efficiently to help stop a fire before it starts.

Extinguish the Fire, Not the Business

3M™ Novec™ 1230 Fire Protection Fluid

3M™ Novec™ 1230 Fire Protection Fluid is a sustainable HFC alternative that works quickly, cleanly and efficiently to help stop a fire before it starts.

Extinguish the Fire, Not the Business

3M™ Novec™ 1230 Fire Protection Fluid 3M™ Novec™ 1230 Fire Protection Fluid is a sustainable HFC alternative that works quickly, cleanly and efficiently to help stop a fire before it starts.

Elements of effective protection

  • 3M™ Novec™ products for safety
    Safety

    Protecting your assets and your people.
    Provides the largest margin of safety relative to all other clean agents, giving peace of mind for the health and safety of your workers.

    Learn More

     

  • 3M™ Novec™ products for performance
    Performance

    No Water, No Damage, No Worries.
    Designed to quickly extinguish fires leaving valuable electronics and other sensitive materials clean and operational.

    Learn More

     

  • 3M™ Novec™ products for sustainability
    Sustainability

    Protecting Your Business and the Environment.
    By switching from an HFC to Novec 1230 fluid, which has a global warming potential of less than one, greenhouse gases in fire suppression can be reduced by more than 99 percent.

    Learn More
     

     

  • U.S. EPA Announces Procurement Recommendations for Federal Agencies

    February 4, 2016

    The U.S. Environmental Protection Agency (EPA) released its recommendations for U.S. federal agencies to help them purchase more environmentally sustainable products and services in accordance with Executive Order 13693.

    On September 25, the U.S. Environmental Protection Agency (EPA) released its recommendations for purchasing environmentally preferable products and services to the U.S. federal government, one of the world’s largest purchasers. This action is aimed at helping federal agencies purchase more environmentally sustainable products and services in accordance with Executive Order 13693, while reducing public health and environmental impacts associated with the federal government’s extensive supply chain.  

  • November 17, 2015

    After six years of negotiation, the highly anticipated “contact group on the feasibility and ways of managing hydrofluorocarbons (HFCs)” was formed. At the 27th Meeting of the Parties to the Montreal Protocol (MOP) in Dubai, all 197 countries agreed to “work within the Montreal Protocol to an HFC amendment in 2016 by first resolving challenges by generating solutions in the contact group.”

    November 5, 2015 marks the day when the 27th Meeting of the Parties to the Montreal Protocol (MOP) decided to form the “contact group on the feasibility and ways of managing hydrofluorocarbons (HFCs)” – putting the production of HFCs on a path for global phase-down. Click here to learn more about the Parties’ path forward.

     

  • October 27, 2015

    The Obama Administration and private-sector leaders announced new ambitious commitments and robust progress of existing commitments to reduce the use and emissions of potent greenhouse gases, called hydrofluorocarbons (HFCs), a critical component of the President’s Climate Action Plan. SEVO™ Systems, Inc. announced it has already achieved a reduction of almost two million metric tons of carbon dioxide (CO2) equivalent by using 3M™ Novec™ 1230 Fire Protection Fluid, a non-HFC clean agent for fire suppression.

    On October 15, 2015, senior White House and Administration officials met for a second time with a broad range of industry leaders at the White House to recognize their significant progress and dedication to curb their emissions of HFCs. Many of these industry leaders, including private-sector producers of the chemicals, manufacturers of equipment that use HFCs, and end-users, publically committed to reducing HFCs at a White House Roundtable in September 2014. One year later, the actions they have taken under those commitments should cut the consumption of HFCs by the equivalent of more than 100 million metric tons of CO2 through 2025, according to a Fact Sheet from the White House.

  • October 13, 2015

    The Society of Fire Protection Engineers (SFPE) has recognized six of its members as Fellows for 2015, including 3M’s Senior Fire Protection Specialist, Paul Rivers. As a 2015 SFPE Fellow, Rivers represents a distinguished group of members who have achieved a standard of excellence and have made significant contributions to fire protection engineering and the society globally.

    After nearly 40 years as a member of SFPE International, Paul Rivers, P.E., Senior Fire Protection Engineer at 3M, has been elected an SFPE Fellow for 2015 for his significant achievements and contributions in the fire protection industry. He has been actively involved in SFPE on both international and local levels, serving on the society’s Board of Directors and currently acting as the Minnesota Chapter President.

Industry Solutions

  • In a data center, the equipment is the central core of the business. 3M™ Novec™ 1230 Fire Protection Fluid is designed to work fast and effectively, minimizing downtime costs and helping preserve business continuity.

     

  • Engineered to keep crew members safe, vital equipment functional, and operations running smoothly, 3M™ Novec™ 1230 Fire Protection Fluid is certified by marine approval authorities around the world.

     

  • All secure. Enhance fire safety while reducing environmental impact – 3M™ Novec™ 1230 Fire Protection Fluid helps protect people and equipment from fire. Non-corrosive and non-conductive, it evaporates cleanly without leaving residue - helping reduce clean-up costs and return aircraft back to service faster.

     

  • 3M™ Novec™ 1230 Fire Protection Fluid is safe for use on paper, canvas and similar materials. It does not leave a residue and will not affect ink, paper, pencil dye, paint or other media.

  • 3M™ Novec™ 1230 Fire Protection Fluid is driving to a future with environmentally sustainable solutions with exceptional performance,  safety and environmental properties.

     

3M™ Blue Sky℠ Warranty

20-year protection against environmental regulations

Learn More

3M™ Blue Sky℠ Warranty

20-year protection against environmental regulations

Featured Videos

Download Product Literature

Where to Buy

Frequently Asked Questions View All

Product FAQs

Products_FAQs_SiteArea
  • What is 3M™ Novec™ 1230 Fire Protection Fluid?

    Novec 1230 fluid is a sustainable chemical that extinguishes fire by heat absorption. It is also considered a “clean” agent that will not damage the area or products being protected when extinguishing exposed areas and products when extinguishing a fire hazard.

  • Is Novec 1230 a liquid or a gas?

    Actually, it is both. Novec 1230 fluid is produced and stored as a liquid. However, upon discharge (in a quick ten seconds), it turns into a gaseous state. The gas then “floods” the protected space to quickly eliminate the fire threat as well as prevent re-ignition of the potential fire incident. (Note: the term “fluid” can be used to describe either a liquid or a gas.)

  • How does Novec 1230 fluid actually change from a liquid to a gas?

    Novec 1230 fluid has a very low heat of vaporization, approximately 25 times less than that of water. As a result, Novec 1230 fluid evaporates more than 50 times quicker than water. This allows the fluid to transition from a liquid to a gaseous state very rapidly when discharged through a nozzle. In a properly designed system, Novec 1230 fluid will quickly vaporize and evenly distribute itself throughout the space being protected.

Installation and Deployment FAQs

InstallationAndDeployment_FAQs_SiteArea
  • Where is Novec 1230 fluid typically installed?

    Because Novec 1230 fluid will not harm or damage any property in the room being protected, systems designed for use with the product are typically installed to protect high value or critical operations in spaces such as computer rooms, control rooms, cultural facilities or any other locations where the process of extinguishing a fire cannot damage the property, its contents, or allow a shutdown of the work process.

  • How is Novec 1230 fluid actually applied on a fire?

    While 3M produces Novec 1230 fluid, it is discharged on a fire hazard using the detection, piping, and nozzles of 3M’s original equipment manufacturer (OEM) partners. Each system is customized to match the needs of the area being protected. When changes to a room are detected such as smoke, particles or heat increases, the Novec 1230 fluid is released into the room, usually from nozzles in the ceiling. The system is automatic, meaning that it will offer protection on a 24/7 basis.

  • Is there a requirement to have a dedicated ventilation system to remove Novec 1230 fluid after a discharge?

    An active mechanical process that is designed to remove Novec 1230 fluid/gas from the protected space is not required by any of the recognized codes or standards. That said, the designer of a system using Novec 1230 fluid may consider use of such a ventilation system on a case-by-case basis if conditions warrant, similar to what has been done in the past with halon.

Sustainability FAQs

Sustainability_FAQs_SiteArea
  • What does the F-gas regulation, specifically the hydrofluorocarbon (HFC) cap and phase-down, mean for the fire suppression market?

    Under the cap and phase-down, HFC-producers will be allocated a production/import quota for HFCs and will have difficult decisions to make. Because the quota will be in CO2 equivalent and HFCs sold into the fire suppression market have some of the highest GWPs, this framework does not favor HFCs sold into fire suppression. For example, an HFC producer would consume the same percentage of a quota by making either one ton of HFC-227ea, three tons of HFC-245fa, or five tons of HFC-32. This dynamic will put a substantial amount of uncertainty on the future supply and cost of HFCs sold into fire suppression. Given that fire suppression systems can easily be in situ for 20 or more years, any HFC-based system already installed or purchased over the next few years will likely be affected by the F-gas Regulation. So, suddenly, HFC-based fire suppression systems may not only be faced with immediate price consequences but also, as future supplies of HFCs are increasingly tightened, the future cost of refilling a discharged system may dramatically increase, and there may also be end-of-life costs when a system is ultimately decommissioned.

  • Can 3M guarantee that Novec 1230 fluid will not be the object of environmental restrictions in the future?

    While no one can accurately predict what the future will bring, 3M is so confident that Novec 1230 fluid will not be affected by any environmental mandates that it now offers the 3M™Blue Sky℠ Warranty.

  • What is the 3M™Blue Sky℠ Warranty?

    The 3M™Blue Sky℠ Warranty offers peace of mind to our global customers including those regions directly impacted the by the F-gas Regulation. Specifically, the Blue Sky Warranty offers: 3M warrants, for a period of 20 years after original installation and subject to noted requirements, that 3M™ Novec™ 1230 Fire Protection Fluid, installed in an approved* fire suppression system, will not be restricted for use in fire protection due to its Ozone Depletion Potential (ODP) or Global Warming Potential (GWP) and is not targeted for phase-down by the Montreal Protocol, nor subject to the European F-gas regulations targeting the phase-down of production and import of HFCs into Europe; and will not be affected by U.S. EPA SNAP regulations which would render it either unacceptable or acceptable subject to narrow use limits.

Safety FAQs

Twisties_HumanOccupancy
  • Is this product safe for human occupancy?

    Yes. Novec 1230 fluid has received all of the required global approvals from third party testing agencies (such as Underwriters Laboratories) to validate extinguishing and design concentration for the product. 3M has tested Novec 1230 fluid to validate there is a large margin of safety for use at these design concentrations. The safety of Novec 1230 fluid has also been reviewed by the U.S. EPA SNAP Office and other independent authorities. The key industry standard from the National Fire Protection Association (NFPA 2001) recommends that personnel evacuate an area prior to the discharge of any clean agent system. However, if individuals are present during the discharge, they will not be affected by the agent.

  • Does the discharge of clean agent suppression systems cause frostbite?

    No, a properly designed fire suppression system will not cause frostbite, because the nozzles are positioned to avoid impingement directly on personnel. Although the temperature of a room may decrease a few degrees, there is certainly no danger of frostbite to any individual in the room. It simply will not occur.

  • Can I purchase a Novec 1230 fluid fire suppression system from 3M?

    No. 3M manufactures Novec 1230 fluid but the actual sales and installations of the systems are through our OEM partners and their global networks of distributors.